Killswitch kits come with Race approved lanyard, screws, switch, and instructions
PMR Killswitch
New killswitch replaces this bracket.
PM-45 Stealth Killswitch kit
Black anodized to match your factory assembly
$79.95
The PMR Killswitch was designed to stop the engine if the rider loses control of their bike. Our switch is a normally closed type switch and replaces the stock bar clamp on most 7/8 handle bars.
- Fits Motorcycles and Quads from Suzuki, Honda, Kawasaki, Yamaha
- CNC machined from 6061-T6 Aircraft Grade Aluminum
- Stainless Steel screws included
4. Designed to replace factory brake or clutch mounting bracket.
- May fit other makes & models
- Made to be used with 4 stroke motorcycles.
This PMR Killswitch fits all brand of motorcycles with the clutch or brake assemblies for 7/8 handle bars made by Nissin (look on the back of your assembly you should see the name somewhere) with a bolt hole spacing of 32mm center to center.
Please check this to verify before ordering.
Patents Pending
Patents Pending
PM-300 Stealth Screw kit
Two Stainless Black Oxide Screws
PM-300 only fits the Barswitch and Killswitch
$7.95
2 Screws sold per kit
PM-305 Killswitch Plug
$14.95
PM-370 Racing Associations Approved Killswitch Lanyard with Plug
$24.95
New PM-47 Stealth Barswitch Killswitch Combo!
PM-47 Stealth(Black) Killswitch-Barswitch Combo Kit
Black anodized to match your factory assembly
$109.95
The NEW PMR Lanyard is made per racing association rules.
It is made from coated aircraft cable and is super flexible.
The ends are lupped back then crimped. The clasp is made from metal for even more strength.
PM-380 Racing Associations Approved Killswitch Lanyard without Plug
$19.95
All Killswitches Now Come with Race Approved Lanyard
$49.95
Many people have asked us to make a back barclamp so they can mount our barswitches or killswitches on any bike with a 7/8 diameter handlebar. So here it is! This will allow you to mount any killswitch or 2 bolt (hydraulic bolt pattern PM-53, PM-50, PM-54, PM-45, PM-47 etc) Barswitch made by PMR. Many people use this for drag bikes with no clutch lever or you can now add switches to dirtbikes or quads. We use this to mount switches on our KTM dritbike(see picture below). One switch is used for the 8" HID headlight and the other is used for the fan)
This is CNC machined and then black anodized to match the barswitches and killswitches.
PM-78B Black Barclamp
Mounted on a KTM 525 XC-W
This is not a cheap back clamp. It is quality! It is strong. It is CNC machined Aircraft aluminum then anodized to match the barswitches.
Your One Stop Motorcycle Speed Shop
